...
Syntax: delete session table [ conn-id <connection identifier> | destination <dst-addr[:dst-port]> | nat46 | nat64 | source <src-addr[:src-port]> ]
Use this command to delete all the entries from the dataplane session table.
...
monitor log - monitor last lines of message files
poweroff - poweroff the system
Syntax: poweroff [ at <time> | cancel | now ]
Powers off the system. Only users with administrative (admin)-level permission can run this command.
reboot - reboot the system
Syntax: reboot[ at <time> | cancel | now ]
Reboots the system. Only users with administrative (admin)-level permission can run this command.
reset - reset a service
reset ip arp address - reset ARP cache for an IPv4 address
Syntax: reset ip arp address <ipv4>
Removes the entry associated with a specific IP address from the ARP cache.
reset ip arp interface - reset ARP cache for interface
...
Syntax: reset ip arp address <interface name>
Removes the entry associated with an Ethernet interface from the ARP cache.
show arp
show date
Syntax: set date [ <datetime> | ntp <ntpserver> ]
Set the system date and time either directly or by specifying an NTP server from which to acquire them.
show hardware cpu
show hardware dmi
...
set console keymap
set date
set system image
set terminal
Syntax: set terminal [ key query-help [ disable | enable ] | length <number> | pager <program> | width <number> ]
Sets the behavior of the system terminal.
key query-help - enables or disables help using the question mark. The default option is enable.
pager - the program to use as the terminal pager. If no pager is specified, the default (less) is used.
Configuration mode
system boot-loader
...